Mill/drill head PF 250/BL钻铣磨机头 PF250/BL

Converts your lathe PD 250/E or PD 400 into a complete machining centre.将您的PD 250/E或PD 400车床改造成一个完整的加工中心。

Mill/drill head PF 250/BL

Incudes column (Ø 35 x 400mm), mounting bracket and fastening screws (the PD 250/E and PD 400 already come with a plane-milled surface). The lathe's top slide is replaced with the table (supplied) of 110 x 70mm, with 3 T-slots. The lathe now functions as a compound table, with X-Y travel being longitudinally and cross-wise respectively. The mill/drill head is identical to the miller FF 250/BL. Three collets of sizes 6 - 8 and 10mm are included.

NO 24 112

磨机/钻头PF 250/BL

插入柱（Ø35 x 400mm）、安装支架和紧固螺钉（PD 250/E和PD 400已经具有平面铣削表面）。车床的顶部滑块被替换为110 x 70mm的工作台（提供），带有3个T形槽。车床现在用作复合工作台，X-Y行程分别为纵向和横向。铣床/钻头与FF 250/BL铣床相同。包括三个尺寸为6-8和10mm的夹头。

货号：24 112

注：此处描述的车床不包括在交付范围内。

Multiple range collet type ER-16 (DIN ISO 15488)
For FF 250/BL and PF 250/BL. One of each Ø 2,4 - 3 - 3,2 - 4 and 5mm. Supplied in a wooden box with sliding lid.

ER-16型多量程夹头（DIN ISO 15488）

适用于FF 250/BL和PF 250/BL。Ø2,4-3-3,2-4和5mm各一个。装在带滑动盖的木箱中供应。

NO 24 146


Fine feed for accurate adjustments during milling
For FF 250/BL und PF 250/BL. Quick and easy to install. The clutch system enables feed via either the drill handle or the handwheel. The handwheel has 0.025 graduations and may be set to zero. 1 division = 0.05mm.

精细进给，可在铣削过程中进行精确调整

适用于FF 250/BL和PF 250/BL。安装快速简单。离合器系统可通过钻柄或手轮进行进给。手轮有0.025个刻度，可以设置为零。1分割=0.05mm。

NO 24 140